HP Netserver E 60 Installation Guide

Chapter 4 Installing Mass Storage Devices

Embedded SCSI Controller Configuration

Typically, no configuration of the embedded SCSI controller is required. You do

have the option of reassigning the designation of channel A and B. In order to

verify or modify SCSI host adapter settings, or to low-level format SCSI disks or

verify SCSI media, run the SCSI Select Utility. See Chapter 11, "Using the BIOS

Setup and SCSI Select Utilities," for further information.

CAUTION You may not connect high voltage differential (HVD) SCSI

devices on the embedded SCSI bus or you will damage the

devices.

Tools Required

To secure the hard disk drives in the hard disk drive cage, you will need a Torx

15 driver or ¼-inch flat blade screw driver. Check your device's documentation

for additional tool requirements.

Installing Hard Disk Drives

1. If the system is already installed and working, gracefully power down the

system as described in Chapter 2.

2. Disconnect the power cables and any external cables connected to the

system. If necessary, label them to expedite reassembly.

3. Remove the cover and turn in the system feet (so that the system will lay

flat on its side) as described in Chapter 3.