HP Netserver E 60 Installation Guide

Chapter 6 Installing Additional Boards

4. Lay the server on its side (components showing).

5. Read the documentation that is included with the accessory card. Note any

special instructions.

NOTE Adding a PCI-to-PCI bridge card to the HP NetServer may

alter the server's boot order. This boot order can be changed

using the SETUP utility (press [F2] during the boot process).

Refer to Chapter 4, "Installing Mass Storage Devices," and see

the subsection, "Boot Priority."

6. Identify the accessory slot number to be used. Note that Slot 6 (closest to

the edge) is a shared slot for ISA and PCI. This means that you may only

use one of these slots at a time (see Figure 6-1).

Slot 1 — PCI

Slot 3 — Full-length PCI

Slot 4 — Full-length PCI

Slot 6 — Full-length PCI

or ISA

Slot 5 — Full-length PCI

Slot 2 — PCI

Figure 6-1. Accessory Slots

NOTE For slot recommendations for specific PCI cards, see the

Readme file, Tested Products List, or Configuration Advisor

on your HP NetServer Navigator CD-ROM (for instructions,

see Chapter 9).