HP Netserver E 60, LC 3, LH 3/3r, and LPr Processor Upgrade Guide

Chapter 3 Installation in LC 3 and LH 3/3r

Removing a Processor Module Without a Processor Retaining Latch

To remove a processor module that does not have a processor retaining latch:

1. Press in on each processor module release latch until it remains in (see

Figure 3-5). If the latch does not stay in, you must hold it in while

removing the module.

Processor Eject Lever

Processor

Mounting

Bracket

Processor Module

Release Latch (Two Places)

Figure 3-5. Removing a Processor Module Without a Processor

Retaining Latch

2. Lift up on the processor ejector lever until the processor pops out of the

processor slot (see Figure 3-5).

CAUTION Do not move the processor ejector lever beyond its limit

(about 25-30 degree angle from the original position). The

ejector lever may break if forced.