HP Netserver E 60, LC 3, LH 3/3r, and LPr Processor Upgrade Guide

Chapter 4 Installation in E 60 and LPr

To install a VRM in an HP NetServer LPr:

1. Orient the VRM as shown in Figure 4-6. The component side of the VRM

faces the center of the system board. Do not touch the components on the

VRM.

Secondary

Processor

Module

Secondary

Processor

Position

VRM

Secondary VRM Slot

Do Not Touch VRM

Components

Figure 4-6. Installing a VRM in an HP NetServer LPr

2. Gently press the VRM down into the socket until it is seated completely.

CAUTION When installing the VRM, push only on the edge of the main

VRM board. Do not push on the large flat surface (if your

VRM model has one) or any components on the board.

Pushing on any part of the VRM except the edge of the main

board may result in damage to the VRM. Damage caused by

improper installation is not covered by any HP warranty.

3. Verify that the VRM is installed completely in the socket. When the VRM

is installed completely, the release latches at the ends of the socket will be

closed.