HP Netserver E 60, LC 3, LH 3/3r, and LPr Processor Upgrade Guide

Chapter 4 Installation in E 60 and LPr
45
CAUTION Do not push in on the VRM release latches; the release
latches will close automatically when the VRM is installed
completely. If the VRM is not installed completely, pushing
in on release latches may damage the latches, the socket, or
the VRM.
Installing Terminator Board for Single-Processor NetServer
A single-processor system board should already have a terminator board installed
in the secondary processor position. If not, install the terminator board originally
supplied with the NetServer:
1. Orient the terminator board as shown in Figure 4-7.
Terminator
Board
Secondary
Processor
Position
Figure 4-7. Install the Terminator Board in a Single-Processor
HP NetServer E 60 or LPr