HP Netserver E 60, LC 3, LH 3/3r, and LPr Processor Upgrade Guide
Chapter 1 Introduction
2
CAUTION Do not attempt to use the existing processors or VRMs from
the HP NetServer LC II system board. They are not
compatible with the HP NetServer LC 3 system board.
About This Guide
This guide describes the procedure for installing a Pentium II or Pentium III
processor module into the HP NetServer E 60, LC 3, LH 3/3r, and LPr. It also
describes how to install a voltage regulator module (VRM) into the HP NetServer
LC 3, LH 3/3r, and LPr.
• Chapter 2 tells how to prepare for the upgrade.
• Chapter 3 describes the upgrade installation for HP NetServer LC 3 and
LH 3/3r.
• Chapter 4 describes the upgrade installation for HP NetServer E 60 and
LPr.
• Chapter 5 tells how to verify the installation.
Accessory Kit Contents
Verify the kit contents. This accessory kit includes the following items:
• Pentium II or Pentium III processor module
• Processor retaining latch (for HP NetServer LC 3 and LH 3/3r)
• Voltage regulator module (VRM, for HP NetServer LC 3, LH 3/3r,
and LPr)
• Label with settings for HP NetServer LC 3 and LH 3/3r system switches
• Pentium III label for the front bezel (for Pentium III processors only)
• HP NetServer Navigator CD-ROM for E-series NetServers
• HP NetServer Navigator CD-ROM for L-series NetServers
• HP NetServer Online Documentation CD-ROM