hp lp 1000r and ds2100 config guide - for Microsoft Windows 2000 A.S. Clusters PDF, 252K, 11/15/2001

LP1KR2K2M21
11/15/01 6
NOTES:
1. To connect server to DS2100 --
2.
3. Only connect channel 0 of
the NetRAID-2M to the DS2100.
Using channel 1 is not supported.
4. There are no ‘left’ or ‘right’ port
requirements for cabling to the DS2100.
Cables can be attached to either port.
This diagram shows using
one DS2100. You can use from
one to two storage cabinets per
cluster. The next figure shows
two DS2100s in a cluster.
C7541A - 2 Meter ILT cable
connect to
NetRAID-2M
channel 0 only!
LAN B
- Client LAN
Heartbeat
Connection
-crossover cable
or equivalent
LAN A
LAN B
- Client LAN
Heartbeat
Connection
-crossover cable
or equivalent
LAN A
LAN B
- Client LAN
Heartbeat
Connection
-crossover cable
or equivalent
LAN A
5. Connect LAN ports A for the heartbeat
cluster interconnect. Use ports B for the client
LAN connection.
6. Here, the DS2100 SCSI ID switch is set to .
The following addresses will be assigned to installed
disks: 8, 10, 12, and 14. Setting B or C is supported.
B
SCSI Switch
A B C
×
×
HP Netserver LP 1000r Cluster using one HP Surestore DS2100 Disk System