HP Netserver LH 3000 NetRAID-4M Config Guide for Windows 2000 Advanced Server Clusters

3
NetRAID-4M FAST 2.4-0 or later
SCSI ID 6, 7
Channels 0, 1, 2, 3
RAID levels All fault tolerant RAID types supported by controller: 1, 5, 10 (Stripe set
of mirror sets RAID 0/1), 50 (Stripe set of RAID-5 sets), Volume set of
mirror sets, Volume set of RAID-5 sets
Containers Single-level or multi-level
Must be fault-tolerant
8 maximum per cluster
Configuration
options:
Write Cache Disabled
Clustering Enabled
Domain Validation Enabled
Cabinet
Disk drives: Any HP drive supported by storage enclosure. Any combination of HP
disk models is allowed in a diskset, on a SCSI channel, or in a cluster.
No. of cabinets 1 – 8
Model Rack Storage/12 D5989B or C plus two D6205B or two D6025C SCSI
controllers for each Rack Storage/12
Status SCSI ID 5 (fixed)
Disk SCSI Ids 0 – 3, 8 – 15 (fixed)
Cables Any 2 HP LVD SCSI offset cables per RS/12 from the following list:
1 meter D7131A
2.5 meter D6020A
5 meter D6982A
10 meter D6983A
LANs
Intra-cluster (Heartbeat) LAN Client LAN
LAN connection HP D5954A crossover cable or
equivalent.
Any LAN
The intra-cluster LAN may only be
used for cluster node
communication. It may not be used
for client communication.
NIC:
Model Embedded NIC Any that is on both the HP Tested
Products List and the Microsoft
Hardware Compatibility List.
Driver Hptxnt5.sys 4.02.27 (Navigator
L.20.00) or later
Vendor supported driver
NOTE If the NIC used is the
same as the Intra-cluster LAN
(HP D5013B), then the Client
LAN must use the same driver as
the Intra-cluster LAN.
No. of NICs 1 1 minimum