HP Netserver LH Pro NetRAID Installation Guide
Overview of an HP NetServer LH Pro Cluster Installation
HP NetServer LH Pro Microsoft Cluster Installation Guide - 1 October 1997 4
Setup Procedure
You begin a cluster installation by setting up the hardware at both HP NetServer LH Pros, referred to here as System
A and System B. The installation is complete when you have setup and tested the Microsoft Cluster Server software
on both systems.
A Microsoft Cluster Server based on HP NetServers is assembled in six major parts:
•
Part 1. Install Additional Hardware components
•
Part 2. Setup the Storage System/6
•
Part 3. Configure the NetRAID adapters
•
Part 4. Install Windows NT 4.0 and configure LAN adapters
•
Part 5. Install NetRAID software and configure disk arrays
•
Part 6. Install and test MS Cluster Server software
As you proceed through these instructions, pay close attention to the order in which components are installed and
systems are brought up. Be sure to configure the systems in the sequence outlined above. Departing from the
procedures presented here may cause unnecessary work and unpredictable results. To begin the cluster installation,
continue to "Part 1: Installing Additional Hardware Components."