HP Netserver LH Pro NetRAID Installation Guide

HP NetServer LH Pro Microsoft Cluster Installation Guide - 1 October 1997 5
Part 1: Installing Additional Hardware Components
When HP NetServer LH Pros are shipped from the factory, they are configured for stand-alone operation. The first
step in creating a cluster is to reconfigure the two HP NetServers for use in a cluster. Because these steps involve
opening the HP NetServers, HP recommends you use a Portable Field Service Grounding Kit (3M part number
8505, or equivalent). The kit contains a wrist strap, anti-static mat, and cable. Using this kit prevents damage to the
system from static electricity.
NOTE The steps outlined below are duplicated on both HP NetServer LH Pro systems (System A and System B).
You may proceed through all the steps on System A, and then repeat on System B, or you may choose to perform
each step on both systems before moving to the next step.
To install additional hardware components at Systems A and B:
1. Assemble the required hardware components listed in the requirements for the HP NetServer LH Pro
cluster, except the HP Storage System/6 unit(s). Separate the components into two systems designated
System A and System B.
2. Remove the cover from the HP NetServer LH Pro as shown here.
Removing the Cover from the HP NetServer LH Pro