HP Netserver LH Pro NetRAID Installation Guide

Part 5: Installing HP NetRAID Software and Configuring the Disk Arrays

HP NetServer LH Pro Microsoft Cluster Installation Guide - 1 October 1997 17

Connecting the Cluster’s Shared Storage

Refer to one of the following schematics as you connect the HP Storage System/6 cabinet(s) to the cluster’s

NetServers. Use only D5957A NetRAID Cluster Adapters to connect the HP Storage System/6 to the servers.

To connect the HP Storage System/6 unit(s) to the HP NetServers:

1. Power down all cluster hardware including both HP NetServers and the HP Storage System/6 cabinet(s)

2. Install the hot swap disks in the HP Storage System/6 cabinet(s).

NOTE If you are using two HP Storage System/6 cabinets, proceed to steps 5 and 6 where you add cluster

adapters for channel 1. Otherwise, proceed to "Connecting the LAN Adapters.".

3. Connect System A’s NetRAID channel 0 to the SCSI A port located on the back of HP Storage

System/6 #0.

4. Connect System B’s NetRAID channel 0 to the SCSI B port located on the back of HP Storage

System/6 #0.

HP NetServer LH Pro Cluster with One HP Storage System/6

5. Connect System A’s NetRAID channel 1 to the SCSI A port located on the back of HP Storage

System/6 #1.

6. Connect System B’s NetRAID channel 1 to the SCSI B port located on the back of HP Storage

System/6 #1.

SCSI-B SCSI-A

CD-ROM

SYSTEM

DISK

NetRAID

Ch0 Ch1

stem A S

stem B