HP Netserver LT6000r Technical Reference Label

System Board Assembly
E
I/O Board (Front)
I/O Board
F
Memory Guidelines
G
NetRAID Cache Memory Socket
PCI Hot-Swap Separators
(See Installation Guide)
I/O Board (Rear)
6
5
4
3
2
1
System Board Connectors
Flexible Disk Drive
Connector
CD-ROM
Connector
Slot 6:
Slot 5:
Slot 4:
Slot 3:
Slot 2:
Slot 1:
Hot Plug 66 MHz
Hot Plug 66 MHz
Hot Plug 33 MHz
Hot Plug 33 MHz
Non-Hot Plug 33 MHz
Non-Hot Plug 33 MHz
D9143-80200
Use only DIMMs of the following sizes:
The maximum memory configuration is 8 GB.
Memory must be added in pairs of equal sizes. For example, a 1 GB DIMM
installed in socket 1A must be paired with a 1 GB DIMM in socket 1B.
You can mix DIMM sizes. For example, a 1 GB DIMM can be installed in
socket 1A, and a 256 MB DIMM can be installed in 2A.
Memory can be added in pairs in any order to the three remaining socket pairs.
When installing DIMMs, do not rock the DIMM into its socket.
Apply firm and even pressure until the DIMM is seated in the socket.
Use only HP-supported DIMMs. Note: if non-HP DIMMs are used, the
NetServer will report this when it boots.
128 MB
256 MB
512 MB
1 GB
•
•
•
•
•
•
•
Voltage Regulator
Modules (VRMs)
3
2
1
6
5
4
Heat Sink
Processors
Processors
1A
2A
3A
4A
1B
2B
3B
4B
3
2
4
6
5
1
Barcode of P/N