Installation and configuration of the HP NetRAID, NetRAID-1 and NetRAID 3Si Adapters

Chapter 10 Understanding HP NetRAID Utilities
115
HP NetRAID Config
HP NetRAID Config performs the same functions as HP NetRAID Assistant, but
it runs under Novell NetWare, SCO UNIX, SCO UnixWare, IBM OS/2, and
Banyan VINES. HP NetRAID Config allows you to reconfigure and manage your
RAID system and monitor its status.
You do not need to reboot your HP NetServer to use HP NetRAID Config.
The command you use to start HP NetRAID Config utility depends on which
NOS you are using.
• For Novell Netware, type load megamgr
• For SCO UNIX, type megamgr
• For SCO UnixWare, type megamgr
• For IBM OS/2, type megaconf
• For Banyan VINES, type megaconf
For a list of functions performed by HP NetRAID Config, see the menu chart that
follows.
For complete instructions on using HP NetRAID Config, see the HP NetRAID
Series User Guide.