HP NetServer Installation Guide for the HP NetRAID-4M and Microsoft Cluster Services with Microsoft Windows NT Server 4.0 Enterprise Edition

HP NetRAID-4M Cluster Services Installation Guide Hardware, Drivers and Utilities

NOTE When the Domain Validation feature is enabled, the HP NetRAID-4M controller

performs a series of Read/Write buffer tests to check bus integrity and has the

option of reducing the transfer rate if necessary, until data integrity is ensured.

10. Press ESC and confirm to save changes by selecting Yes.

11. On the same server, repeat the preceding steps for any used channels, including SCSI

Channel 1, 2 , and 3. Be sure to use the same SCSI ID as used for Channel 0.

Verify disk drives are operational

12. Press ESC twice to return to the Main Menu.

13. Select Disk Utilities. Press Enter.

14. Select a Channel# and press Enter.

15. The screen should display all of the drives in the HP RackStorage/12 that are attached to

Channel#. In addition you should see devices on SCSI ID 6 or 7.

NOTE The RackStorage/12 reserves SCSI ID 5 for the enclosure. On each used channel,

SCSI ID 5 displays HP D5989x.

16. Press ESC to back out and select each channel being used to verify that the drives are

being seen.

17. Press ESC and confirm the rebooting of the server by selecting Yes to exit the HP

NetRAID-4M Controller Configuration Utility.

18. Repeat steps 1 – 17 above for Server B. (Be sure to use SCSI ID 6 for Server B).

2.4 Install Windows NT Drivers

HP NetRAID-4M Disk Array Controller Driver

1. Verify that the HP RackStorage/12 units are powered on.

2. Allow Server A to fully boot to Windows NT.

3. Log on.

4. Open My Computer and double-click on the Control Panel icon.

5. Double-click on SCSI Adapters