HP NetServer Installation Guide for the HP NetRAID-4M and Microsoft Cluster Services with Microsoft Windows NT Server 4.0 Enterprise Edition

HP NetRAID-4M Cluster Services Installation Guide Hardware, Drivers and Utilities

21. Select the Link Speed & Duplex option and then from the Value list select the 100

Mbps/Full Duplex option; click OK to continue.

22. Click Close and the Internet Protocol (TCP/IP) Properties windows will pop up.

23. Select the option to Use the following IP Address:.

24. Enter a private IP address. For example:

Server A: 10.1.1.1

Server B: 10.1.1.2

Subnet Mask: 255.0.0.0

DNS Server: Leave blank

NOTE The client LAN IP and heartbeat LAN IP addresses must be on different subnets.

The heartbeat LAN IP addresses on each node must be on the same subnet, and the

client LAN IP’s on each node must be on the same subnet.

25. Close the Network windows.

26. Select No when asked to reboot the system and proceed to the next section.

Install the HP NetRAID-4M FAST Utility

27. Insert the first HP NetRAID-4M FAST Utility installation diskette in the floppy drive.

28. Navigate to the A:\ directory and double-click on setup.exe.

If the HP NetServer Navigator CD-ROM is used, go to path:

\\NSNavigator\periph\nraidadp\nt\us\setup.exe