HP NetServer Installation Guide for the HP NetRAID-4M and Microsoft Cluster Services with Microsoft Windows NT Server 4.0 Enterprise Edition

HP NetRAID-4M Cluster Services Installation Guide Hardware, Drivers and Utilities

2.1 Create Installation Floppy Diskettes

NOTE Refer to an HP NetServer Cluster Configuration Guide for the supported versions

of the Navigator CD, server BIOS and NetRAID-4M firmware and driver.

1. Power on Server A and immediately insert the HP NetServer Navigator CD-ROM into the

Server A CD-ROM drive.

2. Allow Server A to boot from the HP Navigator CD-ROM.

3. If the HP Navigator prompts you to update the NetServer BIOS, do so and then return here

to continue.

4. Click the language box to select preferred language, then Continue.

5. Verify or set today’s date and time and click Continue.

6. From the menu, select the MS Windows NT 4.0 Enterprise Cluster Server option and

click Continue.

7. Select the Diskette Library option to create the following installation diskettes:

NOTE HP does not currently support loading drivers directly from the HP NetServer

Navigator CD-ROM, but directory paths to the FAST and Cluster Kit installation

utilities on the CD-ROM are provided later in this document.

• NOS Drivers (for the server model that you are using) – two diskettes are required

(The second diskette in this option is for the D5013B HP 10/100BaseT LAN Adapter

driver.)

• NetRAID Firmware: NetRAID-4M (D9161A, D9151A, D9352A) – Diskette 1 is

bootable and runs a firmware flash utility. Two diskettes required or use the HP

NetServer Navigator CD-ROM.

• NetRAID Software-NT/Win2000 (for NetRAID-4M) – contains the HP NetRAID-4M

FAST (Flexible Array Storage Tool) Utility – three diskettes required or use the HP

NetServer Navigator CD-ROM.

• NetRAID Software-NT/Win2000 Cluster (for NetRAID-4M) – HP NetRAID-4M

Cluster Setup Software (Cluster Kit) – two diskettes required or use the HP

NetServer Navigator CD-ROM.