HP Netserver LH 4 Installation Road Map

8
1. Remove cover 2.
Remove the cover as described in panel 6, "Removing and
Replacing the Covers."
Install Additional Memory
NOTE Use only HP DIMMs listed in HP Information
Assistant or in HP Order Assistant.
Memory Rules:
5. Replace the memory boards.
DIMMs must be installed four at a time, two per card.
DIMMs must be installed in banks, from 1 to 4.
J1 and J2 of memory A and B are bank 1.
J3 and J4 of memory A and B are bank 2.
J5 and J6 of memory A and B are bank 3.
J7 and J8 of memory A and B are bank 4.
DIMM types cannot be mixed per bank.
DIMMS are 64 or 256 MB.
DIMMs are EDO buffered TSOP at 50 ns.
Insert each memory board, one at a time, into its guide, and
press it into its socket. The retaining clips flip along the sides of
the board when it seats. The memory boards need to be
identical, so it does not matter which board is Memory A or B.
2. Open the memory cage cover.
Loosen the cover screw. Swing the cover open.
3. Remove both memory boards.
Release the latches and remove both boards. Place them on a
suitable anti-static surface.
4. Install DIMMs.
Align the notches on the DIMM with the keys on the Memory board
socket.
Holding the DIMM at 90 degrees to the system board, press the
DIMM fully into the socket until the retaining clips close. If the clips
do not close, the DIMM is not inserted correctly.
6. Close memory cage cover.
Swing the memory cage cover closed, and tighten the screw.
Memory Cage
Hard Disks
7. Replace cover 2.
Replace cover 2 as described in panel 6.
Latches
Keys
Notches