Compaq 4000/7000 Racks Installation Guide

Chapter 1 Introduction
8
Tools
The following tools are required to install the HP NetServer in a Compaq rack:
l T15 Torx
®
driver
l Small thin flat-bladed screwdriver
l Pozidriv or Phillips screwdriver
Needle-nose pliers may also be helpful.
Terms
Terms used in this document are defined in the table below.
Table 1-2. Terms
Term Definition
Cage nut Single nut designed to clip behind the rack column and
accept a screw through the hole in the column.
Slide Extendible side bracket that is attached to the rack
enclosure columns, onto which the HP NetServer is
mounted. Consists of a stationary component and an
extendible member (see Figure 3-3). Allows access to the
HP NetServer after it is installed in the rack chassis.
Slide mounting flange Mounting flange located at either end of the slide (see
Figure 3-3).
Rack (rack enclosure) The equipment enclosure into which the HP NetServer will
be installed.
EIA unit Industry standard measurement (1.75 inches / 44.45 mm),
consisting of three vertical mounting holes in a rack
column.