Compaq 4000/7000 Racks Installation Guide

Chapter 2 Preparing the HP NetServer
14
Remove the Control Panel Bezel
NOTE Do not remove the original HP rack-optimized control panel
bezel until you have received the Compaq rack-optimized
control panel bezel.
Remove the existing control panel bezel, as shown in Figure 2-4. Push in on the
snap latches on the left and right ends of the control panel bezel, and gently pull
the control panel bezel away from the HP NetServer.
Control Panel Bezel
Snap Latch
(2 Places)
Figure 2-4. Removing the Control Panel Bezel