Compaq 4000/7000 Racks Installation Guide

Chapter 2 Preparing the HP NetServer
19
Remove the Existing LCD Cover
WARNING The LCD cover contains sheet metal with sharp edges. Handle
it carefully to avoid injury.
Do the following to disassemble the existing LCD cover:
1. Use a thin flat-blade screwdriver to bend the twelve spring fingers on the
cover away from the LCD. The detail in Figure 2-10 shows six of the
twelve spring fingers. Bend all twelve enough to reduce their spring
tension. They do not have to actually stay bent back. This is preparation for
Step 4.
Spring Finger
(12 Places)
Screw
(2 Places)
LCD Assembly Detail
LCD
Figure 2-10. Removing Screws and LCD Assembly
(HP NetServer LXr 8500 Shown)
2. Remove the two screws from the sides of the LCD cover as shown in
Figure 2-10.