Compaq 4000/7000 Racks Installation Guide

Chapter 2 Preparing the HP NetServer
24
Reconnect the LCD Cables
CAUTION When connecting the LCD cables, push the connector straight
into the socket. This protects the connector pins from being
bent.
Reconnect the LCD cables to the front panel board, as follows:
1. Push the ribbon cable connector onto the corresponding socket, as shown
in Figure 2-15. Then push down gently on the top flap to secure the
connector.
Ribbon Cable
Connector
Top Flap of Ribbon
Cable Connector
Twisted-pair Cable
Connector
Front Panel Board
Figure 2-15. Reconnecting the LCD Cables (HP NetServer LXr 8500 Shown)
2. Push the twisted pair connector onto the corresponding socket, as shown in
Figure 2-15.