Compaq 4000/7000 Racks Installation Guide

Chapter 1 Introduction
4
NOTE Until you receive the Compaq rack-optimized front bezel,
control panel bezel, and LCD cover:
• Leave the HP-optimized control panel bezel in place.
• Do not close the front door (if any) of the Compaq rack
because it would interfere with the HP-optimized control
panel bezel.
• Do not remove the HP-optimized front bezel.
Order of Installation Operations
What you do when depends on whether you have received the Compaq
rack-optimized kit when you first install the HP NetServer in the Compaq rack.
Table 1-1 summarizes the following two alternatives:
l Received Kit: If you already have received the Compaq rack-optimized
kit, proceed through Chapters 2, 3, and 4 to prepare the HP NetServer,
prepare the Compaq rack, and install the HP NetServer in the rack.
l Awaiting Kit: If you want to install the HP NetServer in the Compaq rack
before you receive the Compaq rack-optimized kit, refer to Chapters 3 and
4 to prepare the Compaq rack and install the HP NetServer in the rack.
After you receive the kit, refer to Chapters 2 and 4 for installation
instructions.