Compaq 4000/7000 Racks Installation Guide

Chapter 1 Introduction
5
Table 1-1. Alternative Installation Operations
Received Kit: Initial installation of
HP NetServer with the Compaq
rack-optimized kit
Awaiting Kit: Initial installation of
HP NetServer without Compaq
rack-optimized kit, followed by later
installation of kit
1. Remove bezel latch, control panel bezel,
and LCD cover (Chapter 2).
1. Prepare Compaq rack (Chapter 3).
2. Install new LCD cover and new control
panel bezel (Chapter 2).
2. Install HP NetServer into rack with
existing LCD cover and control panel
bezel, but no front bezel (Chapter 4).
3. Prepare Compaq rack (Chapter 3). 3. After the kit is received: extend
HP NetServer from rack (Chapter 2).
4. Install HP NetServer in rack (Chapter 4). 4. Remove bezel latch, control panel bezel,
and LCD cover (Chapter 2).
5. Install Compaq rack-optimized
nameplate and front bezel (Chapter 4).
5. Install new LCD cover and new control
panel bezel (Chapter 2).
6. Install Compaq rack-optimized
nameplate and front bezel (Chapter 4).
Compaq Rack Precautions
WARNING To prevent the rack from tipping over and causing equipment
damage or bodily injury, be sure that the stabilizing, anti-tip
feature is installed on this rack enclosure (see Figure 1-2).
To prevent the rack from tipping over and causing equipment
damage or bodily injury, do not extend more than one piece of
equipment at a time out of the front of the rack enclosure.