HP Netserver LPr Installation Guide

Chapter 13 Troubleshooting
101
◊ If you have changed any switches on the system board, check that they
are properly set.
5. Reseat the system board in the card edge connector to the I/O board.
6. Turn on the display and HP NetServer LPr.
7. If the HP NetServer LPr still does not work:
◊ Repeat steps 1, 2, and 3 of this section.
◊ Remove all accessories, except the primary boot hard disk drive.
◊ Replace the cover and connect all cables.
◊ Turn on the display and the HP NetServer LPr.
◊ If the HP NetServer now works, replace the boards and accessories one
at a time to determine which one is causing the problem.
Clearing the System Configuration
You may need to clear the system configuration if the configuration has been
corrupted by a program, or if incorrect settings made in the Setup utility have
made the display unreadable.
To clear the system configuration, follow the steps on the next pages.