HP Netserver LPr Installation Guide

Chapter 13 Troubleshooting
107
Battery Problems
If your HP NetServer LPr repeatedly loses its configuration or the CPU clock
stops, you should replace the battery or install an auxiliary battery.
WARNING There is a danger of explosion if the battery is incorrectly
installed. For your safety, never attempt to recharge,
disassemble, or burn the old battery. Replace only with the
same or equivalent type recommended by the manufacturer.
Dispose of used batteries safely.
Installing a Replacement Battery
1. Turn off power to the HP NetServer LPr and unplug it.
2. Remove the front bezel and top cover (see Chapter 3).
3. Carefully, remove the old battery. Do not bend the clip that holds it in
place.
Battery
Figure 13-2. Battery on System Board
CAUTION
Dispose of the lithium battery properly. Disposal is regulated
in many jusrisdictions.