Manualshelf

HP Netserver LPr Installation Guide

ManualsBrandsHP ManualsServerHP NetServer LH 3000
31323334353637383940
Chapter 4 Installing Mass Storage Devices
25
Hot-Swap Drive Bay Addresses
The hot-swap bays are addressed from left to right as 0 and 1. The system will
default to booting from the drive with SCSI ID 0 on the left bay.
SCSI ID 0
SCSI ID 1
Figure 4-1. Hot-Swap Bays
Other SCSI Device Addresses
Other SCSI devices connected to LPr’s embedded SCSI channel can never use
device ID 7 (the embedded SCSI controller). Other SCSI devices can use device
IDs 0 and 1 if those hot-swap bays are not in use.