HP Netserver LPr Installation Guide

Chapter 4 Installing Mass Storage Devices
26
Configuring the SCSI Host Adapter
In order to verify or modify SCSI host adapter settings, or to low-level format
SCSI disks or verify SCSI media, run the Symbios Configuration Utility. See
Chapter 11, "Configuring the NetServer LPr," for further information.
Installing Hot-Swap Drives
CAUTION Protect the drive from static electricity by leaving it in its
anti-static bag until you are ready to install it. Before
handling the drive, touch any unpainted metal surface to
discharge static electricity. When you remove the drive from
the anti-static bag, handle it only by the frame.
Do not touch the electrical components. Place the drive on
the anti-static bag whenever you set it down.
Hard disk drives are very susceptible to mechanical shock and
can be damaged by a drop as short as one-quarter of an inch.
Take care when unpacking and handling the drive. If the
drop would crack an egg, it will damage the drive.