HP Netserver LPr Installation Guide

Chapter 4 Installing Mass Storage Devices

Installing Hot-Swap Drives

3. Slide the drive slowly into the hot swap bay until it stops. See Figure 4-4.

CAUTION Be careful not to damage the light pipes as you insert the

drive. They are very fragile.

You must insert the drive slowly and gently. If the drive is

inserted too quickly when the system is on, in-rush current

can cause the power supply to shut down.

4. Press the ejector handle in until you feel the latch click into place. Closing

the ejector handle engages the drive with the electrical connector in the

hot-swap mass storage cage and seats the drive.

5. If

the drive is unseated in the cage after closing the ejector handle, the

handle was probably not pulled out far enough, and the locking latch

failed to engage the hot-swap mass storage cage. Repeat from step 2.

Figure 4-4. Installing a Drive in the HP NetServer LPr