HP Netserver LPr Installation Guide

Chapter 5 Installing Additional Memory
32
WARNING The power supply will continue to provide standby current to
the NetServer LPr until the power cable is disconnected.
4. Remove the NetServer from the rack. See the last section in Chapter 9,
"Removing the NetServer from the Rack."
5. Remove the top cover from the NetServer (see Chapter 3, "Opening and
Closing the HP NetServer LPr").
CAUTION Wear a wrist strap and use a static-dissipating work surface
connected to the chassis when handling components. Ensure
that the metal of the wrist strap contacts your skin.
6. Locate the DIMM sockets (see Figure 5-1).
CAUTION Use only HP DIMMs.
Figure 5-1. DIMM Locations
7. Install the DIMMs (see Figures 5-2 and 5-3):
a. Remove a DIMM from its container, handling the module by its edges.
Lay it on an anti-static surface.
b. Choose a socket into which you want to install a DIMM. DIMMs may
be installed in any combination, in any socket.