HP Netserver LPr Installation Guide

Chapter 7 Installing Additional Boards

Figure 7-2. Remove PCI Card Access Panel

6. Apply pressure at the top of the PCI access cover to pop it out.

7. Read the documentation that is included with the PCI card. Note any

special instructions.

NOTE Adding a PCI-to-PCI bridge card to the HP NetServer may

alter the server’s boot order. This boot order can be changed

using the SETUP utility (press [F2] during the boot process).

Refer to Chapter 4, "Installing Mass Storage Devices," and see

the subsection, "Boot Device Priority."

8. Identify the PCI slot number to be used.