HP Netserver LPr Installation Guide

51
Chapter 8 Installing Additional
Processors
Introduction
The NetServer LPr supports up to two processor modules. Processor modules are
available at different clock speeds. Both processor modules must operate at the
same clock frequency.
The processor upgrade kit includes the HP NetServer Navigator CD-ROM. Boot
with this CD-ROM after installing the additional processor to update the BIOS.
Tools Required
These tools are required for removal and installation of CPU modules:
•
If you have to remove the LPr chassis from the rack, use Torx T25 driver.
Refer to the last section of Chapter 9, "Removing the NetServer from the
Rack" for instructions.
•
An anti-static service kit (3M

8501/8502/8503 or equivalent). This kit
includes a static-dissipating work surface, a chassis clip lead, and a wrist
strap.
Installation Steps
Verify Contents
CAUTION Do not remove the processor from its bag until you are ready
to install it. Make sure the bag remains sealed. The CPU
chips are sensitive to humidity, so desiccant has been packed
in the bag containing the processor board. When the
processor board has been installed and the HP NetServer is
running, the chips are no longer sensitive to humidity.
Unpack the shipping box and verify that you received the contents in the
following list for the processor accessory kit.