HP Netserver LPr Installation Guide

Chapter 9 Mounting the Server in the Rack

Step 4: Assemble the rails.

To assemble the two rails:

• Slide the rail pieces together.

• Both rails work on either side of the rack.

Figure 9-8. Assembly of the Rails

NOTE As you go through the following steps, finger tighten the

screws holding the rails, rear stops, and the LPr chassis to the

rack. Once all the parts are in place, use the T25 driver to

tighten all 12 screws in a couple of passes as you apply

downward pressure on the chassis to ensure it seats correctly.