hp lp 2000r and ds2100 config guide - for Microsoft Windows 2000 A.S. Clusters PDF, 205K, 11/15/2001

LP2KR2K2M21
11/15/01 6
NOTES:
1. To connect server to DS2100 --
2.
3. Only connect channel 0 of
the NetRAID-2M to the DS2100.
Using channel 1 is not supported.
4. There are no ‘left’ or ‘right’ port
requirements for cabling to the DS2100.
Cables can be attached to either port.
This diagram shows using a
single DS2100. You can use from
one to two storage cabinets per
cluster. See the next cabling
diagram for a configuration using
two DS2100s.
C7541A - 2 Meter ILT cable
connect to
NetRAID-2M
channel 0 only!
LAN B
- Client LAN
Heartbeat
Connection
-crossover cable
or equivalent
LAN A
LAN B
- Client LAN
Heartbeat
Connection
-crossover cable
or equivalent
LAN A
5. Connect LAN ports A for the heartbeat
cluster interconnect. Use ports B for the client
LAN connection.
6. Here, the DS2100 SCSI ID switch is
set to . The following addresses will be
assigned to installed disks: 8, 10, 12, and 14.
Setting B or C is supported.
B
SCSI Switch
A B C
×
×
HP Netserver LP 2000r Cluster using one HP Surestore DS2100 Disk System