HP NetRAID-4M Installation Guide

1-4
Hewlett-Packard NetRAID-4M Controller Installation Guide
System Requirements
The following are the minimum system requirements for the
HP NetRAID-4M:
■ A 75 MHz Pentium computer that complies with PCI Rev. 2.1
or greater. If the Motherboard has bridged slots, then the
bridge needs to be PCI Rev. 2.1 or greater compliant.
■ A minimum of 64 MBytes of main memory.
■ An available full length, either 32- or 64-bit 33 MHz,
unobstructed 5-volt or 3.3-volt PCI slot that supports bus
mastering and 5v power signalling.
■ One 64 MByte EDO DRAM DIMM (Dual-In Line Memory
Module) with ECC for cache memory (included with
controller).
■ 32 MBytes of available hard disk space for the HP NetRAID-
4M software.
■ One of the following:
– Windows NT 4.0 Server, Small Business Server Edition.
– Windows NT 4.0 Server, Terminal Server Edition.
– Windows NT 4.0 Server, Enterprise Server Edition.
– Windows NT 4.0 Server, BackOffice Edition.
– Windows NT 4.0 Workstation (for installing the controller’s
GUI).
Display file system type No Yes Yes
Detect when the file system
can be extended
No Yes No
Create, remove, or extend the
file system
No Yes No
Detect when a container is a
system or boot partition
Yes (boot
only)
Yes Yes
Synchronizes display between
GUI and DM
No No No
1
The disk always gets a signature to avoid NT disk administrator pop-ups.
Tools and Capabilities BIOS CLI GUI