HP NetRAID-4M Installation Guide

1-5
Introduction
Note: All Windows NT systems require Service Pack
6A or higher.
– Windows 2000.
– NetWare 4.20 with Support Pack 7 or higher.
– NetWare 5.0 with Support Pack 1 or higher.
– NetWare 5.1 with Support Pack 1 or higher.
– SCO OpenServer 5.0.5
– SCO UnixWare 7.1.1
– Red Hat Linux 7.0
■ A 3.5-inch, 1.44-MByte floppy disk drive.
■ CD-ROM drive.
■ SCSI cables to connect the internal or external HP NetRAID-
4M 68-pin connectors to the SCSI devices. Depending on the
configuration, from one to four cables may be required
(internal cables are included with the controller).
Conventions
This document uses the following typographic conventions:
bold
Used for key names (… press the Enter key …) and for options
you are told to select (… select Configure SCSI Channels…).
Helvetica
Used for screen messages (…Save changes?…) and for text
that must be typed exactly as shown.
Helvetica Italics
Used for program and file names when referenced in the text
(… these changes are made to the config.sys file…).
This document includes three kinds of advisories: