HP NetRAID-4M Installation Guide

4-5
Installing the Device Drivers
4 Press Enter to select the following Hewlett-Packard driver:
HP NetRAID-4M RAID CONTROLLER.
5 Press Enter at the message Setup has recognized the following
mass storage devices to continue with the Windows NT
operating system setup. Follow the instructions onscreen and
in the Windows NT documentation to complete the
installation.
Note: During the final phase of the Windows NT installation
you will be prompted to reinsert the drivers diskette.
Installing the Drivers When Windows NT is Already
Installed
To install the drivers when Windows NT is already installed on your
system, follow these steps:
1 Go to the Control Panel and double-click SCSI Adapters.
2 In the SCSI Adapters dialog box select the Drivers tab and
click Add.
3 Click Have Disk.
4 Insert the diskette labeled NOS Drivers - Windows
NT4.0/Windows NT 4.0 Cluster <NetServer Name> Disk #1. .
and browse to the HP NetRAID-4M directory.
Click OK.
5 Select the listed drivers — HP NetRAID-
4M RAID CONTROLLER — and click OK.
6 At the message Do you want to restart the computer now?,
remove the diskette from the floppy drive and click Yes to
reboot the system.
Note: Instead of rebooting now, you may elect to
install the controller management software first, and
then reboot. For instructions on how to install the
controller management software, see Chapter 5,
Installing the Controller Management Software.