HP NetRAID-4M Installation Guide

4-13
Installing the Device Drivers
10 Answer Yes to the prompt Do you want to copy driver
netr4m.ham?
11 Specify the path where you want the netr4m.ham driver
installed or press Enter to accept the default.
12 You will be prompted to save the existing driver and its
attendant files. Answer Yes to these prompts.
13 Select Select/Modify driver parameters and press Enter.
14 Press Ctrl-Esc, and from the next menu select to return to the
System Console.
15 At the console prompt, type load a:\netr4m.ham and press
Enter.
A list of slot numbers separated by commas is displayed.
Record the slot number for the HP NetRAID-4M controller, but
do not press Enter.
16 To prevent the driver from being loaded at this time, press Esc.
Ignore the message that the netr4m.ham driver is not loaded.
17 At the console prompt, press Alt-Esc to return to the install
screen.
18 Enter the slot number recorded in step 15 and press Enter, and
then press Esc.
19 Select Save parameters and load driver and press Enter.
20 Respond No to the prompt, Do you want to select an
additional Disk driver?
21 Press Esc until you return to the Installation Options menu. If
necessary, modify the load command line in the
startup.ncf file
so that the proper path to the driver and all appropriate
command line options are specified. See Loading the NetWare
Drivers at Server Bootup on page 4-17. Otherwise, exit the
install program.
22 Install the Novell NetWare Support Pack 7 or higher for
Version 4.20.