HP NetRAID-4M Installation Guide

4-22
Hewlett-Packard NetRAID-4M Controller Installation Guide
the HP NetRAID-4M controller, which on the open source
distribution is called the aacraid driver.
■ Openserver
Openserver does not require that you remove already existing
drivers.
■ UnixWare
a To determine if the hpnraid driver is installed on your
UnixWare system, enter the following command:
pkginfo hpnraid
If the hpnraid driver exists on your UnixWare system, the
pkginfo command will return a message like the
following:
system hpnraid Hewlett-Packard Raid Driver
b If the hpnraid driver already exists on your UnixWare
system, remove it by doing the following:
i Execute the following command to access the Device
Configuration Utility:
/sbin/dcu
ii Choose Hardware Device Configuration from the
menu.
iii Under the Device Name column, locate the entry
hpnraid.
iv Using the F2 key, change the Y in the first column to an
N.
v Press the F10 key to exit the Hardware Device
Configuration.
vi At the Device Configuration Utility main menu, choose
Select Apply Changes & Exit DCU.
vii Remove the hpnraid driver from the system by entering
the following command:
pkgrm hpnraid
You will be prompted to confirm the deletion; answer
yes to the prompt.