HP Netserver E 60, LC 3, LH 3/3r, and LPr Processor Upgrade Guide

Chapter 4 Installation in E 60 and LPr
41
Removing the Existing Processor Module
If you are upgrading an existing processor module, you must first remove the
existing module from the slot.
To remove a processor module:
1. Slide the blue plastic release levers to free the processor module, as shown
in Figure 4-4.
2. Remove the processor module from the processor mounting bracket.
Slide Levers to Free
Processor Module
Processor Module Processor Mounting Bracket
Figure 4-4. Removing the Processor Module from HP NetServer E 60 or LPr