HP Netserver LH 4: Entry-Level Enterprise Server

• Processor: Up to 4 Intel Pentium II Xeon
400MHz processors with 512KB or 1MB
cache.
• Product Design: 8U rack-optimized
configuration. LH4 can be configured in a
rack or as a pedestal.
• ECC Memory: 256MB 50ns ECC
buffered EDO DRAM with memory
scrubbing, expandable to 4GB.
• Mass Storage: Up to 12 hot-swap Ultra 2
SCSI drives, (supports mixture of low-
profile and half-height drives) plus two
common tray bays.
• I/O Expansion Slots: 8 total full length
PCI (including two 64-bit slots, one slot
taken by pre-installed NIC, and one shared
PCI/ISA).
• Ultra2 SCSI Controller: Integrated dual
Ultra2 controllers, with additional Ultra2
to single-ended converter.
• Disk Array Controller: Integrated dual-
channel HP NetRaid controller with I
2
O,
supports additional HP NetRaid-3SI
controller with three Ultra2 SCSI channels.
• Network Interface: Bundled 10/100TX
PCI LAN NIC
• Tape Backup Support: Internal HP
SureStore DLT for high speed data
recovery, internal HP SureStore DAT
24x6 autoloader for one week unattended
backup.
• System Management Software: HP Top
Tools with intuitive browser-based
interface for device management. HP
OpenView ManageX/SE for NOS and
Application management.
• Remote Administration: Integrated HP
Remote Assistant. Optional HP Top Tools
Remote Control card with browser based
LAN access.
• Installation & Configuration: HP
NetServer Navigator for faster
deployment.
• Power Supplies: 3 hot-swap power
supplies standard, plus 1 optional, with
dual cords.
• Fans: 8 Totally Cool hot-swap fans
standard
• Support Options: Support can be
delivered either by your local reseller or by
Hewlett-Packard.
• Solution Delivery: Racks Express offers
pre-configured, pre-tested delivery of rack
solutions to resellers or end users.
Fact Sheet
November 3, 1998
HP NetServer LH4: Entry-Level Enterprise Server