HP Netserver LH 4 NetRAID-3Si Installation Guide

Configuration

options:

Cluster mode on

Cache write-policy to Write-thru

Set bus speed in Rack Storage/8 to Ultra

Set any other options as you prefer

Cabinet

RAID arrays A RAID array (logical disk) must be composed of all the same disk model

(i.e., part number and suffix). Different size or speed disks are not

allowed in the same RAID array. Any combination of disk models is

allowed on a SCSI channel. Any combination of disk models is allowed

in a cluster.

Number and Mix of

cabinets:

1 – 3 any mix of Rack Storage/12 and RackStorage/8

Rack Storage/12:

Model D5989A plus 1 D6025A for each Rack Storage/12 (400, 450 MHz)

D5989B plus 1 D6025B for each Rack Storage/12 (500, 550 MHz)

Status SCSI ID 5 (fixed)

Disk SCSI IDs 0 – 4, 8 – 15 (fixed)

Disk drives: HP 9.1 GB Ultra SCSI Disk Module D6106A

HP 9.1 GB (10k rpm) Ultra SCSI Disk Module D6107A

HP 18.2 GB Ultra SCSI Disk Module D6108A

HP 18.2 GB (10k rpm) Ultra SCSI Disk Module D7031A

HP 18.2 GB (7200 rpm) Low Profile Ultra SCSI Disk Module D7174A

HP 36.4 GB (10k rpm) Ultra SCSI Disk Module D8210A

Cables Any 2 HP LVD SCSI cables from the following list:

1 meter D7131A

2.5 meter D6020A

5 meter D6982A

10 meter D6983A

Rack Storage/8:

Model D4902A

Disk drives: HP 4.2 GB Hot-Swap Ultra SCSI Disk Module D3583C

HP 4.2 GB 10K rpm Hot-Swap Ultra SCSI Disk Module D4903A

HP 9.1 GB Hot-Swap Ultra SCSI Disk Module D4289A

HP 9.1 GB 10K rpm Hot-Swap Ultra SCSI Disk Module D6019A

HP 18.2 GB Hot-Swap Ultra SCSI Disk Module D5039A

NOTE All disks in a Rack Storage/8 must be the same speed.

Cables HP D5957A Cluster Adapter

NOTE If both channels 0 and 2 of the NetRAID Adapter are used, then

cable D7131A must be used with Cluster Adapter D5957A on both

channels.