HP Netserver LH 4r Rack Cabling Guide

1 About This Cabling Reference

Introduction

Before You Use This Reference

This cabling reference assumes that you have the rack assembly process

completed, have mounted the HP NetServer LH 4r, and are ready to cable the

components in the rack enclosure.

For instructions on how to install the HP NetServer LH 4r in a rack, consult the

installation guide or user guide shipped with your unit.

NOTE For instructions on how to assemble other components in a

rack, please find and follow the documentation shipped with

your rack components. Look for this documentation first

inside the rack. If there is no such documentation with your

rack, check the separately orderable installation kit. Or, use

the generic rack assembly process described in this chapter.

Purpose of This Document

This reference provides information for cabling the HP NetServer LH 4r,

including power consumption and current requirements. It is written for rack

installers who have installed the HP NetServer LH 4r in a rack and need

information about how to connect data and power cables. It contains:

• A review of the generic steps for building a rack installation

• Site preparation information

• Illustrations of electrical power components

• A diagram for use in connecting data cables between the HP NetServer

LH 4r and other system components

• Illustrations for installing Power Distribution Units (PDU) in the rack

• Power cabling information for rack-mounted electronic components

• Power, current, and component reference information