HP Netserver LP 1000r (1.13, 1.26 & 1.40 GHz) Installation Sheet

Installing the PCI Accessory
Board (Continued)
Latch
Tab Rest
Tabs (2)
Slot Cover
Riser Board
64-bit PCI Slot (1)
Riser Board
(Not Shown)
I
2
C
Connector
System Board
Riser Board
Installed
Latch
PCI Slot
Step B
Insert Long PCI Board
Step C
Close Clamp
Tab Rest
Step A
Open Clamp
Board
Clamp
Installing Memory
Installing the PCI Accessory Board
30 Degrees
Keys
Notches
DIMM Slot
Retaining latches (2)
CAUTION) Ensure you hold the DIMM tightly as you push it 
  straight into the slot. It is possible to turn or bend the 
  DIMM slightly while inserting it, which would damage 
  or break the DIMM socket.
  If a DIMM socket is damaged, you must use another 
  DIMM slot or replace the entire HP Netserver, since 
  this Netserver is not repairable in the field.
DIMM Slots
0
1
2
3
System Board