HP Netserver LP 1000r (1.13, 1.26 & 1.40 GHz) Installation Sheet

4-Post Rack Installation
2-Post Rack Installation (Continued)
Flush Mounting
Center Mounting
3/4 Counter Clockwise
Release
Spring
Assembly
1/4 Clockwise
NOTE) ) Refer to the white paper, HP Netserver High Density  
  Rack Solutions Overview (LP 1000r and LP 2000r) on  
  HP's Web site for high-density rack information.
WARNING) To prevent rack instability while mounting the
  HP Netserver ensure the rack's anti-tip foot is pulled  
  forward out of the bottom. Failure to do so could result in 
  injury and equipment damage.
  To prevent the rack from rolling while you mount the
  HP Netserver, ensure the leveler screws on the rack's  
  lower four corners are in firm contact with the floor.
2-Post Rack Installation
Optional (2)
NOTE) Refer to the white paper, HP Netserver High Density  
  Rack Solutions Overview (LP 1000r and LP 2000r) on  
  HP's Web site for high-density rack information.
NOTE) The installed inner-rails shipped with the HP Netserver 
  are used for the 4-post HP racks. These rails must be  
  removed for 2-post rack installation and replaced with  
  the mounting brackets.
WARNING) To prevent personal injury or damage to the equipment, 
  use two people to mount the HP Netserver into the rack. 
  The HP Netserver weighs 32 lbs (14.5 kg) fully loaded.
Flush Mount Brackets Only
Center Mount Brackets Only