HP Netserver LPr Installation Guide

Chapter 2 Controls, Indicators, and Ports
12
Figure 2-2. Control Panel
Table 2-1. Control Panel Switch and Indicator Definitions
Control / Indicator Description / Definition
Power On/Off
Switch
Momentary switch. When pressed, moves power
status back and forth between System Power and
Standby Power. System Power allows full system
operation; Standby Power enables remote system
monitoring only.
Power On/Off LED
Green when System Power on. If this LED does
not come on, the system is not getting adequate
power or the power supply is malfunctioning.
Reset Switch
Momentary switch. When pressed, creates hard
system reset. This is equivalent to a power-on
reset.
Drive Active LED
LED goes on (green) to indicate access over the
LPr’s embedded SCSI bus. This includes access to
both internal and external drives.