HP Netserver LT 6000r Bezel Adapter

HP Part Number D9143-90016 '&! (&#'

Printed in December 1999

HP NetServer LT 6000r Bezel Adapter Installation Sheet

The HP NetServer LT 6000r comes with bezel adapters included but not installed on the bezel. These adapters ensure

a proper fit between the bezel and the HP NetServer rack. Do not install the bezel adapters when installing the

LT 6000r in a Compaq rack.

Installing the Bezel and Bezel Adapters

1. Remove the bezel from the HP NetServer LT 6000r as follows:

a. Carefully disconnect the control panel cable from the front of the server.

b. Unclip the control panel cable from the clip on the back of the bezel.

c. Lift the bezel off the hinges to remove it.

Control Panel Cable

Control Panel Cable Clip

Figure 1. Remove the Bezel

2. To install the left bezel adapter:

a. Line up the tabs on the bezel adapter with the holes on the inside of the bezel.

b. Push the tabs on the bezel adapter into the holes on the bezel.

PAGE 1
HP NetServer LT 6000r Bezel Adapter Installation Sheet The HP NetServer LT 6000r comes with bezel adapters included but not installed on the bezel. These adapters ensure a proper fit between the bezel and the HP NetServer rack. Do not install the bezel adapters when installing the LT 6000r in a Compaq rack. Installing the Bezel and Bezel Adapters 1. Remove the bezel from the HP NetServer LT 6000r as follows: a. Carefully disconnect the control panel cable from the front of the server. b.
PAGE 2
Figure 2. Install the Left Adapter 3. To install the right bezel adapter: a. Put the adapter top into the top slot on the NetServer. b. Push the adapter into the NetServer. Figure 3. Install the Right Adapter 4. To re-install the bezel on the front of the server: a. Position the holes in the hinge bracket over the hinges. b. Push the bezel down over the hinge.