HP Netserver LT 6000r Rack Cabling Guide

Chapter 2 Rack Cabling References

◊ one or more PDUs can be used in each rack enclosure, depending

upon requirements for power, current, and number of receptacles (see

Table 2-4)

Power Cables and Components Available

When components are installed in a rack, a power supply subsystem for the rack is

required. HP recommends the NetServer LT 6000r be connected as follows:

• connected to a Power Distribution Unit (PDU)--see Figure 2-2

• through an Uninterruptible Power Supply (UPS)--see Table 2-1

• to a properly protected branch circuit or circuits--see "Site Preparation-

Circuit Breakers" in Chapter 1

NOTE A Redundant Switch is available for use between the UPS and

the branch circuit or between the PDU and the branch circuit.

More information is listed in Table 2-2 and in Appendix B.

Table 2-2 lists details of the cables, components, plugs and receptacles for the

rack power supply subsystems for the HP NetServer LT 6000r.