HP Netserver LXr 8000 Installation Guide

Chapter 13 Alternative Rack Mounting
124
WARNING With power supplies in place, the HP NetServer does not
balance evenly when lifted by its handles. Two people may
have difficulty holding the HP NetServer level enough to
fasten it to the slides. Removing the power supplies improves
the balance of the HP NetServer and reduces the likelihood of
accidents.
2. Pull out both slides until their slide members are fully extended. When
you do this, the slides lock into position. You cannot push them back in
the rack without pressing in their release latches. See Figure 13-7.
Slide Member
Slide Member
Figure 13-7. Pulling Out the Slides
WARNING To prevent the rack from rolling while you mount the HP
NetServer, make sure that the leveler screws on the rack’s
lower four corners are in firm contact with the floor.