HP Netserver LXr 8000 Installation Guide

Chapter 5 Installing Additional Memory
44
Installing DIMMs on a Memory Board
Follow these steps to install a DIMM in a slot on a memory board.
CAUTION Use only DIMMs acquired from HP. Contact HP Customer
Support for a list of qualified DIMMs. HP will not support
configurations that use non-HP Buffered EDO DIMMs.
1. Remove the memory board from the computer. See the previous section,
"Removing and Replacing the Memory Board."
2. Place the board on a firm, anti-static surface. The side of the board that
holds the components must face up.
3. Remove a DIMM (Figure 5-10) from its container, handling the module
by its edges. Lay it on an anti-static surface.
Figure 5-10. A DIMM Module
4. Locate the slot where you will install the DIMM. (See Figures 5-4 and 5-5
for recommended DIMM configurations.) Spread the slot’s two DIMM
retaining clips outward. See Figure 5-11.