HP Netserver LXr 8000 Installation Guide

Chapter 6 Installing Additional Boards
55
7. Consider the HP NetServer’s boot order when selecting a slot on the I/O
baseboard (Figure 6-1). If you are installing a SCSI controller board, the
priority of the controllers (where the BIOS will search for the boot drive)
is set by the board’s slot location. Refer to "I/O Board Boot Order" earlier
in this chapter.
8. When you have selected a slot, remove its slot cover on the server's rear
panel.
If you are installing a board in one of the PCI Hot Plug slots (P7 through
P10), first remove the special Hot Plug board bracket from the inside of
the server's rear panel. Then you can remove the slot cover. See Figure
6-3.
Hot Plug Board
Bracket (Loosen
Captive Screw
to Detach)
Figure 6-3. Removing a Hot Plug Board Bracket from a PCI Hot-Plug Slot